11
• The tree house ladder is 7 ft (2.4 m) long
• If you install the floor of your tree house less than 8 ft (2.1 m) in the air, you can remove ladder steps to make the ladder shorter
• The height of the ladder will also determine where you attach the anchor line on your ladder
• NOTE: Keep excess steps and hardware stored away in case you need to extend the length of your ladder in the future.
• Clip the ladder to the 2 metal rings on the
bottom base of the tree house.
• Make sure the wide end of the clip is on the
ladder, and the narrow end is connected to the
tree house. This will help keep the ladder straight
while climbing it.
• The Anchor line will help keep the ladder stabilized
on the tree.
• Weave the end of the anchor line through the 2
loops sewn into the bottom of the ladder
• Slide the line down so that the black metal cam is
positioned at the back of the tree. Open the cam by
pressing down on the metal tab, then feed the anchor
line through the bottom of the cam and pull it tight
against the tree. Roll up the excess line and secure
with elastic loop.
Shortening the Ladder
• Start by hanging the ladder from the tree house or anchor point to determine the ladder height. The first step
should be apx. 12 in (30.5 cm) from the bottom of the tree.
• Any steps that are hanging below 12 in (30.5 cm) from the tree may be removed.
• Once the screws are removed, the
pegs on the back side of the ladder
should come out easily.
•
Once both pegs are removed from the
step, you can then slide the step off the
2 straps of webbing.
• Repeat this process as necessary
until the bottom step is apx. 12 in (30.5
cm) from the ground.
• As each step is removed, there will be
a 2 loops sewn into the webbing where
the step previously was. These loops
will act as the new anchor point for your
anchor line to attach through. Tie
excess strap in knot under the anchor
strap.
• Remove the bottom step(s) by
unscrewing the 2 screws on the
outside edge of each step.
YOU WILL NEED
U4. Anchor Line X1
U1. Verticle Webbing Staps X2
U2. Carribeaner
U3. Ladder Steps X6
U4
U5. Pegs X12
STEP 9.
INSTALL LADDER
