b2audio Mono, Owner'S Manual, Page: 5 / 11

Mono
GND (GROUND CONNECTION)
For connection to the chassis’ ground.
For optimum performance 0 gauge cable is
required & shall be kept as short as possible.
REM (REMOTE)
Connection to sw12V from the head unit.
5
Installation of the amplifier should be done
1. Disconnect the negative lead from the battery prior to any installation.
in the folling steps:
2. Ensure that the ground is appropriate, then connect it to the amplifier.
3. Connect the +12V wire. The cable has to be fused at both the battery
(
within 20 cm)
& the amplifier with the correctly dimensioned fuse.
4. Connect the switched remote from the HU, then reconnect the battery.
5. Operation over 16V will cause the amplifier to go into protect mode.
CAUTION
2. Panel layout
+12V (POWER CONNECTION)
For connection to the positive terminal
of the battery (+12V).
For optimum performance 0 gauge cable
is required.
POWER
B+ REM
GND
Caution
BATTERY
GROUND
Head unit
Remote turn on
200A (External fuses)
Keep GROUND of correct length
& dimension (shortest possible / 0GA).
This drawing is for illustration
purposes only!
SWEET LIKE DANISH