Installation
Above ground Installation
It is recommended to lag bolt the ramp in place to keep the scale from moving during
use. First position the scale and ramp in the location that you intend on using the scale,
ensure that the scale is away from general traffic and that the chosen area is protected
from water, misc. debris, wind, and or vibration.
Once the location of the scale has been chosen, remove the scale from the ramp taking
care not to move the ramp. Using a black Sharpie mark the small bolt holes located on
the foot retaining plate shown in the image below.
Once these holes have been marked, remove the ramp and drill lag bolt holes where
the black Sharpie marks are located on the floor. Once the holes have been drilled
position the ramp back in place and secure it to the floor using lag bolts.
Foot retaining plate
mounting bolt holes.
Foot retaining plate
load cell feet holes.
