14
Mobile Plate Dispenser
OPERATING INSTRUCTIONS
Be careful not to trap your hands (risk of crushing) between the unit and walls or other objects,
such as cabinets.
Avoid subjecting the castors to excessive load to minimise the risk of damage to the castors:
• Do not move the unit when the castor brakes are locked
• Avoid impacts
• Pull the unit carefully over thresholds or steps (without using excessive force)
If the unit is on a sloped surface, it must be secured by extra means, such as wheel chocks, in
addition to applying the castor brakes to prevent it from rolling away accidentally.
The unit can be tilted to an angle of 10° when stationary before it is at risk of tipping over. You
may only cross sloped surfaces with an incline < 10°.
The unit may swerve out to the side when being pushed over a sloped surface. Two people (one
at each side of the unit) are required to move the unit over ramps or recesses.
Disconnecting the mains plug
Insert and remove mains plug only while unit is switched off, as otherwise the unit electrical sys-
tem and the mains socket outlet can be damaged.
Only unplug the mains plug by pulling on the mains plug housing.
Mains plug
Switch the unit off and unplug the mains plug before cleaning. Water penetrating into the unit
can cause a short-circuit. If this happens, there is a risk of electric shock.
Hygiene
You must comply with the specifications in Regulation (EC) no. 852/2004 and your national hygi-
ene regulations.
Cleaning frequency
Clean the unit exterior after each use. Clean the unit interior if necessary.
Cleaning methods
Use approved cleaning methods only.
Do not use steam jet units, high-pressure cleaners, water sprayers or similar cleaning devices.
General information on cleaning agents
Do not use metal parts for cleaning. Metal parts can damage the unit and/or lead to corrosion.
Do not use pointed or sharp objects for cleaning. They can damage the unit.
Do not use scouring agents. Scouring agents scratch surfaces.
Shutting down
Cleaning and care
Summary of Contents for TS-H1
