RELEASE DATE
7-11-14
REFERENCE
NUMBER
INS-1330.2
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
TENAYA2® ICEE™ SERIES
Housing Installation
10. Wipe O-ring clean of debris before re-inserting
patented HydroLock™ plate on to junction box.
Turn HydroLock™ plate clockwise to lock in place
under pins.
B. For a drive-over installation, fill the hole around
the fixture housing to 15” below the finished
grade with clean fill dirt and tamp carefully to
prevent settling of fixture. Pour concrete and
finish as required flush with the top surface of
the Yellow Installation Cover.
Note: Drive-over rated for 35,000 lbs. GVW
A. For soil installation, fill and tamp soil to the
appropriate height leaving room for sod,
pavers, etc. to be level with the top of the
Yellow Installation Cover.
Soil installation is NOT Drive-over rated!
7. Per DIG-IT Guide, backfill the gap between the
bottom of housing and bottom of hole with
sand for drainage.
8. Rotate patented HydroLock™ plate counter
clockwise to allow notch in HydroLock™ plate
to clear pins on junction box. Pull to remove.
9. Pull branch circuit wiring into junction box.
Make watertight connections using waterproof
wire connectors (provided) to leads on the
interior patented HydroLock™ plate.
Concrete/Drive-over
Soil
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
