B-hyve XR Quick Start Manual Download Page 11

Rated input:

Australia—240V AC 50/60Hz 0.15A

Europe—230VAC 50/60Hz 0.15A

USA—120V AC 60Hz 0.2A

Max load:

AUS & EU—24V AC 1 Amp 50/60 Cycle

USA—24VAC 1 Amp 60Hz

Temperature Operating Range:

Operating: 32–158° F (0–70° C)

Storage & transport:

-4–176° F (-20–80° C)

Humidity Operating Range:

Operating: 0–80% | Storage & transport: 0–90%

Altitude:

6,500' (2,000 meters)

IP65 Rating

Installation Class II

Over Voltage Category II 

Battery Specifications:

Timer includes a non-replaceable CR2032 Lithium battery.

This timer works with any standard 24V irrigation solenoid.

The internal fuse is non-replaceable.

FCC & IC Statement

This device complies with Part 15 of the FCC Rules and Industry Canada license 

exempt RSS standards. Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

FCC Warning: Any changes or modifications not expressly approved by the 

party responsible for compliance could void the user’s authority to operate this 

equipment.

Note: This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses, and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help This device 

meets the FCC and IC requirements for RF exposure in public or controlled 

environments. The end user is advised to maintain a distance of 20 cm from the 

controller and any personnel to ensure compliance with RF exposure regulations.

This Class B digital apparatus complies with Canadian ICES-003

DÉCLARATION DE FCC ET L’IC

Cet appareil est conforme à la section 15 de la Règlementation de la FCC et la 

norme RSS d’Industry Canada. Son fonctionnement est soumis aux deux conditions 

suivantes: (1) cet appareil ne doit pas causer d’interférences nuisibles, et (2) cet 

appareil doit tolérer toutes les interférences, dont les interférences pouvant causer 

un fonctionnement non désiré. Cet appareil numérique de classe B est conforme à la 

norme canadienne ICES-003.

Remarque: cet appareil été testé et déclaré conforme aux limites d’exposition pour 

les appareils numériques de classe B, selon la section 15 de la Règlementation de 

la FCC. Ces limites sont conçus pour fournir une protection raisonnable contre 

les interférences nuisibles dans une installation résidentielle. Cet appareil produit, 

utilise et peut émettre de l’énergie radio fréquence et, si elle n’est pas installée et 

utilisée conformément aux instructions, peut causer des interférences nuisibles 

aux communications radio. Cependant, il n’est pas garantie que des interférences 

ne se produisent pas dans une installation particulière. Si cet appareil cause des 

interférences gênantes à la réception d’un signal radio ou de télévision, ce qui peut 

être déterminé en allumant et en éteignant l’appareil, l’utilisateur peut corriger les 

interférences en suivants une des mesures suivantes :

• Réorientez ou repositionnez l’antenne de réception.

• Augmentez la distance entre l’appareil et le récepteur.

• Branchez l’appareil dans une prise sur un circuit différent du circuit sur lequel le 

récepteur est branché.

• Consulter le revendeur ou un technicien radio/TV expérimenté pour obtenir de 

l’aide. Cet appareil est conforme aux exigences de la FCC et de l’IC concernant

l’exposition aux ondes dans un environnement public ou contrôlé. Il

est conseillé à l’utilisateur final de maintenir une distance de 20 cm du

contrôleur pour assurer la conformité aux réglementations d’exposition

RF. Information de conformité pour le Canada

SPECIFICATIONS

THE B-HYVE APP

Install the B-hyve® app on your smart device

You will need a smart device to connect the timer to Wi-Fi.

Note:

 The app will guide you through initial set up of your 

sprinkler timer. In addition, there are help icons throughout the 

app with more information and useful tips.

timer connected 

symbol

running status/

messaging

rain delay

calendar

program list

weather

& temp.

stop watering

next zone

settings

zone list

remote control or 

home button

Need Help?

If the app and the website don’t have what you’re 

looking for, please go to our website before 

returning this sprinkler timer to the store.

call us

1-801-299-5555

text us

801-905-8260

email us

 [email protected]

or visit us at:

mybhyve.com

57985-50 rA

This equipment complies with FCC radiation exposure 
limits set forth for an uncontrolled environment. 
This equipment should be installed and operated 
with minimum distance 20cm between the radiator & your body.

Ce matériel est complété par une exposition de 

rayonnements FCC pour un environnement naturel. 

Ce matériel doit être installé et se faire avec 

une distance minimale de 20cm entre les radiateurs 

et les autresYour body shop.

Summary of Contents for XR












Reviews: