KARAT
®
130/164/300
GB
20
OPERATING MANUAL KARAT® 130/164/300
operatING CoNtroLs
1
LED motor load
2
On/Off switch
3
Waterflow Indicator
4
PRCD protective switch
5
Grip
6
Hex collet
7
Water tap
8
Speed selection switch
9
Ventilation slots
10
Dry Drilling Kit
11
2nd Back Grip
12
Safety screw
13
Feed lever
14
Stand Grip
15
Rod with scale for drill angle adjustment
16
Locking screw
17
Clamping lever for 15
18
Guide block for Karat 130
19
Limit stop plate
20
Base plate
21
Adjusting screws
22
Safety bolt
23
Centering plate
24
Spindle nut
25
Screw assembly
26
Vacuumblock fastening screw
27
Connection for vacuum pump
28
Ventilating tap
29
Seal
30
Transportation wheels
31
Drill bit
32
Rubber cover
33
Fastening screw for water collecting ring
34
Water collecting ring
35
Clamping lever for Quick Release Guide
36
Safety bolt Quick Release Guide
37
Pressure gauge vacuum kit
38
Air vent
39
Filter cap
40
Vacuum gauge
41
Hose clip
42
Suction hose
43
Quick coupling
44
Fluid collecting container with float
45
Mains plug
46
Frame
*Not all of the accessories illustrated or described are
included as standard delivery .
safety GuIdeLINes
The definitions below describe the level of sever-
ity for each warning. Please read the operating
manual and pay attention to these symbols.
DANGER: Indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri-
ous injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTE: Indicates a practice not
related to personal injury which, if
not avoided, may result in property
damage.
INteNded use
The machine is intended for drilling into concrete
and reinforced concrete, when being used in con-
junction with diamond core bits for wet drilling
and a suitable water supply. Karat 130 can also be
used for dry drilling in masonry and other build-
ing materials with the dry drilling kit.
The vacuum pump is intended for the fixation of
drillstands Compact and Large. The pump is only
designed for sucking in air, and no other gases or
fluids.
For damage caused by usage other then
intended, the user is responsible.
Before use
When drilling through walls or floors, make
absolutely sure that there are no obstacles
in the adjoining rooms and cordon off the
building site. Prevent the drilling core from
falling.
