START GUIDE
3
3.
Power Cable Connection
The router requires DC power supply from +10 to +30 V DC. The router has a built-in
protection against reverse polarity without signaling.
Connect power cable to the connector labeled as
PWR
on the front panel of the router
and tighten locking screws (see figure below).
4.
Ethernet Cable Connection
S
Ethernet cable has to be connected to
ETH
connector on the front panel (see figure
below). Ethernet cable is used for configuration and communication with the router.
If expansion ports are assembled, cable is connected to port
PORT1
or
PORT2
. Wiring
of pins for expansion ports are described in manual of corresponding expansion port. These
manuals can be found on the Conel website:
. Please, use
the following login information:
Username:
ConelFreeDownload
Password:
coneldownload
Power
cable
Ethernet
cable
