LogBox-RHT-LCD
Temperature and Humidity Data Logger
0568 0038-01
0141 0315-88 29.11.2021
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Seite
16
von
18
Technische Änderungen vorbehalten
Fon +49 771 83160 | Fax +49 771 831650 | [email protected] | bb-sensors.com
9.4.3
Acquisitions Table Window
Data acquired by one or both input channels (user-defined) are displayed in
engineering units in a table format. The table displays register number,
date/time and the record values
9.4.4
Exporting the Data
Three windows supporting data visualization: Graph, Acquisitions Table and
General Information windows. Data can be originated from direct reading from
the logger or from a file previously recorded in a computer.
Once the windows are open, data can be saved in a file (.lch), printed on a
graph or exported to a text file (.txt or .dat).
10
S
PECIAL
C
ARE
The logger is an electronic device and some basic care is required:
•
When opening the device for battery replacement or connecting sensors avoid touching the circuit for not causing damages resulting
from static electricity.
•
When the device is opened, avoid liquid and/or dust contact.
•
Use a screwdriver to open the case cover.
•
Pay attention to batteries polarity: The positive terminal should be placed directed towards the center of the device.
•
Worn batteries should not be recharged, dismantled or incinerated. After use, batteries must be disposed according to local legal
rules.
•
After placing batteries back to the logger, make sure the cover is firmly attached to the socket.
11
MOST
FREQUENTLY
PROBLEMS
Communication with the logger fails
•
Make sure the COMM port is selected correctly and there is no other program using the same port during communication attempts
•
Make sure there is no physical obstacle blocking the infrared signal; Make sure the cable is well connected to the PC port
•
Make sure the port selected does not present any problem
Logger Reset
When the user is not sure about the real condition of the logger operation, it is possible to perform an enforced Reset by removing the battery
and waiting for 2 seconds to replace it. The logger will return to the stand-by mode. If measurements were being made, it will interrupt the
process and start measurements again only when a new set up is made. Implemented setup remains the same after reset.
12
Q
UESTIONS
?
For further information about this or other products of B+B Thermo-Technik GmbH please do not hesitate to contact us at:
B+B Thermo-Technik GmbH
Tel.: +49 771 83160
Heinrich-Hertz-Straße 4
Fax: +49 771 831650
78166 Donaueschingen
E-Mail: [email protected]
Deutschland
www.bb-sensors.com
Figure 27
Table window
