INSTRUCTION MANUAL
Technical changes reserved
0141 0315-199 September 2010
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | [email protected] | bb-sensors.com
08 / 11
2.3.
The moisture indicator reacts to metal in the same way as it does to humidity. In case there is a nail, an armo-
ring or another metal object to be found in the material to be measured within the radiation area (measuring
plate on back side of device) the value indicated will be too high! Correct measurements cannot be obtained.
2.4.
The moisture indicator GMI15 is no measuring decive and cannot be used in this capacity!
We shall not assume any liability for potential damage resulting from incorrect use of the indicator or from the fact that
the indicator has been used as a measuring device.
2.5.
As soon as „BAT“ is displayed this is an indication that the battery has been used up and needs to be e-
changed. Too low an operating voltage may result in wrong measurements.
Please note:
If the battery voltage falls even lower the voltage may not be sufficient for
„BAT“ to be displayed so that
there will be no „BAT“ indication although the battery has been used up.
We recommend to make it a rule to always check the battery if the values indicated seem to be completely out of
range.
2.6.
The battery has to be taken out, when storing device above 50°C.
It is recommended to take the battery out, when storing device for a longer period of time.
2.7.
Handle the device carefully and use in accordance with above mentioned specifications only (do not throw or hit
against any other object, etc.)