The
AZZA
P4X MAINBOARD SERIES
Page 41
PNP OS Installed
This item allows you to determine if a PnP OS is installed or not.
Reset Configuration Data
Normally, you leave this field Disabled. If you have installed a new add-on and
the system reconfiguration has caused such a serious conflict that the operating
system cannot boot then select Enabled. Selecting Enabled will reset the Ex-
tended System Configuration Data (ESCD).
!
RTC Alarm Resume
When enabled, you can use the following two fields to select the time and
date to wake up the PC system from power saving mode.
!
Date (of Month)/Resume Time (hh:mm:ss)
When RTC Alarm Resume is enabled, your can set the date and time at which
the RTC (real-time clock) alarm awakens the system from Suspend mode.
!
IRQs Activity Monitoring
The following is a list of IRQ’s, Interrupt ReQuests, which can be exempted
much as the COM ports and LPT ports above can. When an I/O device wants
to gain the attention of the operating system, it signals this by causing an
IRQ to occur. When the operating system is ready to respond to the request,
it interrupts itself and performs the service.
CMOS Setup Utility - Copyright (C) 1984 - 2001 Award Software
IRQs Activity Monitoring
Item Help
Menu Level
###
###
###
###
Primary INTR
IRQ3 (COM 2)
IRQ4 (COM 1)
IRQ5 (LPT 2)
IRQ6 (Floppy Disk)
IRQ7 (LPT 1)
IRQ8 (RTC Alarm)
IRQ9 (IRQ2 Redir)
IRQ10 (Reserved)
IRQ11 (Reserved)
IRQ12 (PS/2 Mouse)
IRQ13 (Coprocessor)
IRQ14 (Hard Disk)
IRQ15 (Reserved)
[ON]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
Note:
When set On, activity will neither prevent the system from going into a power
management mode nor awaken it.
Managing The PC BIOS
