MODEL
HL113E
Setup for an Existing Network Connection
D
If in case you have changed the Private Network Name of your
existing network, you may use the Simple Connect Button of your
HL113E and the other devices as indicated below:
Within two minutes,
press the simple connect button of
HomePlug AV X for TWO SECONDS.
3
Step 3
To confirm if the connection has established,
check the LEDs. The Power LEDs and
the Powerline Activity LEDs on all HomePlugs would be ON
.
4
Step 4
NOTES:
When joining an existing network, you only have
to pair it to one HomePlug AV that belongs to the
existing network.
The Ethernet Activity LED will only be lit if it is
connected to an Ethernet device (e.g. computer,
laptop, etc) through an Ethernet cable.
To perform RESET to factory defaults, press the
Simple Connect button for 10-13 SECONDS.
•
•
•
Press the Simple Connect button of your HomePlug
AV X for 10 SECONDS.
After you release the button,
the Power and Powerline Activity LED will turn
OFF and turn ON.
1
Step 1
Press the Simple Connect Button of HomePlug AV Y for
TWO SECONDS.
The Power LED will continuously blink. If
the Power LED did not blink, press the Simple Connect button
again for two seconds.
2
Step 2
Press
for
10-13
SECONDS to perform
factory defaul reset.
HomePlug X
(Your new HomePlug)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
HomePlug X
(Your new HomePlug)
HomePlug Y
(A HomePlug that
belongs to the existing
network)
