Protocol - Modular AC-DSP
V1_version Feb-2011
14
introduced coins. If the validator rejects the coin it will not count for the price
programming.
Coins accepted:
introduce one of each coin that you want to admit. Other coins
available on the validator will be inhibited and it will not accept them.
Service time:
enter the amount of coins you need to reach the time requested
according to the value for time of each coin. The time assigned to each coin should
be specified.
Maximum value programmable 65,535 seconds.
If during the programming, the introduced coin causes the maximum value to be
exceeded, it will be not accepted and its value will not count for the programming.
If the coin is rejected or does not validate properly, it will not be used for
programming.
Token 1 / Token 2
1. Place the dipswitches to be programmed for token 1 or token 2.
2. Put dipswitch SW4 ON. The electromagnet on the acceptance gate will make a
short “click”.
3. Introduce a minimum of 25 tokens that you wish to programme.
4. Put dipswitch SW4 OFF. If the programming was correct, the solenoid on the
acceptance gate will make a long “click”. If the programming was not correct,
the solenoid on the acceptance gate will
NOT
“click” and you will have to repeat
the process from the start.
To programme the second token, it is necessary to repeat the process.
The value of tokens are fixed (value is implemented in factory when the validator is
programmed) and only you can modify them with a Terminal TL20 or similar.
Activate / Deactivate Wide Tables and Bonus.
The process to follow to
activate
wide tables / bonus is as follows:
1. Place the SW1, SW2, SW3 dipswitches with corresponding configuration.
2. Put dipswitch SW4 ON. The electromagnet on the acceptance gate will make a
short “click”.
