Installation:
Hardware Installation :
1. Turn OFF the computer, unplug the power cord and open the
computer case.
2. Pick an available PCI bus master expansion slot and remove the
expansion slot cover. Insert the adapter into the slot until it is firmly
seated. Secure the adapter.
3. Replace the computer cover and connect the network cable to the
newly installed network adapter. Reconnect the computer's power cord
and plug it into the power outlet.
Configuration:
The AZiO
AES100A
is automatically configured when you
power-on your computer, In certain computers, however, you must
modify BIOS by entering CMOS SETUP utility to enable PCI Device and
map INTA to an appropriate address, Please refer to the system
documentation for details on configuration the PCI SYSTEM BIOS.
Driver Installation:
Before you connect adapter to the network, you have to install the
network driver first. The driver for each networking operating system is
under a separate directory. In the directory, there is a file describing
driver's installation procedure.
Boot ROM Installation:
The optional Boot ROM device allows you to connect a diskless
workstation to the network. Perform the following steps to install your
Boot ROM device:
1. Insert the Boot ROM into the socket of the adapter.
2. Refer to the installation procedure provided by networking operating
system (Options: Some adapters need to run SETUP Utility to enable
Boot ROM function)
12-086-01265 Rev:00
