Azbil MCB10A, User Manual

Page: 29 / 114

Azbil Corporation Instrument installation
Model MCB10A 2-7
2-1-4 : Direction of the converter
Introduction
In some locations, the direction of the converter may be unsuitable if the detector is
installed as it is shipped. In such a case, the converter can be repositioned.
After selecting an installation site, adjust the direction of the converter in advance by
the method shown below.
Repositioning the converter
The converter can be repositioned at right angles. Follow the procedure below.
Step Procedure
1 Using an M5 hex wrench, remove the four screws securing the converter.
2 Holding the detector, rotate the converter horizontally to the desired
position.
CAUTION
Do not rotate the unit more than 180° (one half rotation). Any
greater rotation can break wiring parts.
If the converter is removed, make sure that the O-ring, which
provides an air-tight seal, is still fitted into the O-ring groove.
3 Using a hex wrench, re-tighten the four screws to secure the converter.
Hex wrench
Figure 2-5 Repositioning the converter
CAUTION
After removing the screws, do not pull hard on the converter. Otherwise, the lead
wire inside can break.