Azbil MagneW Two-wire PLUS+ MTG15A, User Manual

Page: 161 / 280

6-17
Hierarchical structure of CONFIG functions
Hierarchic structure chart
Each functions of SFC form a hierarchical structure. Before setting using the SFC, check the
positions of the respective sub-functions with the supplied hierarchical structure chart.
The SFC screen displays only two lines, and so if it is not clear which hierarchy is shown, see
the hierarchy chart on page 6-17.
SFC hierarchical structure chart
ID
DAMP
UNIT
URV (100%)
OUTPUT
INPUT
CONF
URV
COEFF
ZERO
UNIT KEY
RANGE CONFIG
DETECTOR DATA
ALARM CONFIG
FAILSAFE CONFIG
DIGITAL I/O
CALIBRATE MENU
CORRECT DAC
TOTALIZE MENU
UNIT
___. ___Spec Gra
RANGE
HYSTERESIS
CUT-OFF
DISP
___. __mA (Ex)
TYPE
DIAMETER
HI ALARM
LOW ALARM
4-20 F/S
PULSE OUT
DI
DO
DO1 NORM
DO2 NORM
EXCIT CUR CHECK
EXCIT CUR CAL
GAIN CAL
INIT DATA RECOV
SHIP DATA RECOV
READ TOTAL
PULSE OUTPUT
SET TRIPVALUE
PULSE CONFIGURE
RESET TOTALIZE
UNIT
P-WIDTH
P-DROP OUT
Key Commands Commands Commands
Starts communication / Set tag no.
Sets damping time
Sets unit
Sets range
Sets correction coefficient
Outputs 4-20 mA
Auto-zero calibration
Set system of units
Sets specific gravity
N/A
N/A
Sets low flow
Selects display cutoff
Sets detector constant
Sets detector type
Sets detector diameter
Sets HIGH alarm
Sets LOW alarm
Burnout (4-20 mA)
Burnout (pulse output)
N/A
Switches contact and pulse
Sets contact output
N/A
N/A
N/A
Gain calibration
Initial data recovery
(Please do not use this function)
Initializing data to factory setting
Corrects output
Read total value
Outputs pulse output
Sets preset value
Pulse weight and unit
Sets pulse width
Sets dropout
Counter reset