Azbil AUR450C, User Manual

Page: 22 / 62

2-2
Chapter 2. MOUNTING AND WIRING
„
Mounting posture
Mount the controller so that the display/control panel is vertical, not horizontal,
and its writing is correctly oriented.
POWER
EVENT
SHUTTER
FLAME
ALARM
START
IG
PV
MV
RST
DISP
FLAME
VOLTAGE
ADDRESS
LOADER
RS-485
DYNAMIC SELF CHECK
BURNER CONTROLLER
AUR450
POWER
EVENT
SHUTTER
FLAME
ALARM
STAR T
IG
PV
MV
RST
DISP
FLAME
VOLTA GE
ADDRESS
LOADER
RS-485
DYNA MIC SELF CHECK
BURNER CONTR OLLER
AUR450
POWER EVENT SHUT
TER
FLA
ME ALARM ST
AR
T
IG PV MV
RST DISP
FLA
ME
VOL
TA
GE
ADDRESS
LO
ADER
RS
-485
DY
NA
MIC SELF CHECK
BURNER C
ONTR
OLLER
AUR450
POWER EVENT SHUT
TER
FLA
ME
ALARM ST
AR
T
IG PV MV
RST DISP
FLA
ME
VOL
TA
GE
ADDRESS
LO
ADER
RS
-485
DY
NA
MIC SELF CHECK
BURNER C
ONTR
OLLER
AUR450
Panel
Panel
Panel
Panel Correct
Incorrect Incorrect Incorrect
Front of
controller
Panel
MADE IN JAP AN
AC xxxV 50/60H z
XXXXX XXXXXX
Panel
Front of controller
MADE IN JAPAN
AC xxxV 50/60Hz
XXXXX XXXXXX
AUR450C 000
Panel
W
iring diag
ram
Front of controller
Correct
Incorrect Incorrect
„
Mounting the subbase
Mount the subbase on a vertical surface. The threaded hole for the body-subbase
screw should be in the lower portion of the vertically oriented subbase.
(1) Open knockout holes on the subbase as required by the wiring situation.
(2) Connect the wiring conduit(s).
(3) Mount the subbase in the desired location with M4 screws, using the 4 mount-
ing holes.
M4 mounting hole (4 locations)
80±0.2
80±0.2
unit: mm
Handling Precautions
•
Although there are 5 holes, use the 4 holes at the corners, as shown in the
above drawing.
•
Tighten the screws with a torque of 1.5 N·m min. Failure to do so may break
the subbase.
(4) Connect the wiring in accordance with the description of Item 2-2 Wiring.