6
display ON. The DMX indicating dot will not turn off for convenience reasons.
Flip display:
Disp
When activating this function, the LED display will flip upside-down. This might be convenient when
the fixture is installed in a certain way and you need to read the values on the display.
Channel mode:
Chnd
This mode changes the DMX channel mode between 1 and 4. Each mode has its own characteristics,
which makes basic, medium or advanced control possible.
Working time:
hour:
It is possible to see the total working time of this fixture, by activating this feature.
Test mode:
test:
The unit will test all its internal programs.
Version:
Vers
This feature is only intended for technical purposes and shows the current firmware version of the unit.
This can not be changed.
DMX control mode:
This fixture can be controlled using a DMX-controller and standard XLR male to XLR female cable.
When doing so, make sure your DMX-controller is capable of controlling your fixture. When in doubt,
contact your local dealer for advice.
Set the correct address on the digital display, you are able to choose a value between 001 and 255.
When a DMX-signal is received, a blinking red dot on the display is active.
NOTE:
At some point, mirror-motors and lenses will be identified by using the numbers 1, 2, 3 and 4.
The numbers apply from left to right. The most left mirror is mirror 1, the most right mirror is mirror 4.
This unit has the following DMX-channels and DMX-values:
1 channel DMX mode
Channel 1:
Pattern
Start value End value
Function
0
7
Blackout
8
17
Chase 1
18
27
Chase 2
28
37
Chase 3
38
46
Chase 4
47
56
Chase 5
57
66
Chase 6
67
75
Chase 7
76
85
Chase 8
86
95
Chase 9
96
104
Chase 10
105
114
Chase 11
115
124
Chase 12
125
133
Chase 13
