Setting up the device
To activate the unit, connect the included power supply to the unit and a suitable 230V, 50 Hz power outlet.
The unit will activate directly after it is plugged in to a wall outlet or other power source.
This device is equipped with dipswitches on the rear, to determine the active working mode and/or DMX
address.
There are 10 dipswitches, each with their own function. The working modes can be activated by turning the
dipswitches on and off in certain combinations.
Auto/manual mode: Dipswitch 10 on, other dipswitches off
DMX mode: Dipswitch 10 off, other dipswitches will determine the DMX-address.
The DMX address is used to place the device on a certain channel in a DMX-chain. This makes controlling
the device with a DMX-controller easier.
Set the correct address by using the dipswitches. Every switch has its own value and by combining values, it
is possible to choose every address between 1 and 512.
Dipswitch 1:
1
Dipswitch 2:
2
Dipswitch 3:
4
Dipswitch 4:
8
Dipswitch 5:
16
Dipswitch 6:
32
Dipswitch 7:
64
Dipswitch 8:
128
Dipswitch 9:
256
Example:
When you wish to turn the fixture to starting address 19, you add the highest numbers possible to
select the channel.
When you want to set the device to DMX-address 19, add dipswitch 5, 2 and 1. (16 + 2 + 1 = 19)
The FLASH 1500D can be controlled with 2 DMX-channels. Each channel has its own function.
DMX channel 1: Speed 0 – 512 (slow to fast)
DMX channel 2: Dimmer 0 – 512 (0-100%)
