In working mode, press the button “ ” and “ ” at the same time to set
automatic off of the product. The LED display will switch to timer setting, the
figures flash on screen, as below:
To deactivate timer function press the button “ ” and “ ” at the same time.
The appliance can be set between 1 to 8 hours, increased at 1 hour intervals.
To adjust the timer press “ ” or “ ” buttons then wait a few seconds for
the setting to be memorized.
Note:
Figures will keep flashing on the screen until the program setting is
finished.
After setting finished, screen will automatically show “Temperature” - “Timer” –
“Temperature” in turns within 5 second each.
Note:
Timer on screen will decrease at 0.1 hour intervals, eg: 2.8 hours.
When the programmed time is reached, the heater stop working, the fan
inside will power off 30s later.
This appliance is provided with a safety device which will switch off the heater in
TIP - OFF SAFETY DEVICE
Press the power switch on the back to “I” position, you can
hear “Bi”, and the heater is in standby mode.
OPERATION
CONTROL PANEL
ON / OFF FUNCTION
1.
2.
3.
4.
5.
5.
TIMER FUNCTION
Press the button “ ” to choose the setting temperature you want during working
mode, which can be set in the order of 15 °C - 35 °C, increased at 1 °C intervals.
(default temperature is 24 °C).
Note
(HIGH / LOW mode):
1
.
2.
3.
The temperature SET should be higher than the room temperature, otherwise,
the appliance will not start heating.
Once the room temperature achieves the target temperature, the appliance
will stop automatically, the fan inside will power off 30s later.
If the room temperature is 1°C less than temperature SET, the appliance will
restart.
TEMPERATURE SETTING
Press the button “ ” to turn on the unit, the indicator lights up in red, LED display
will show room temperature and appliance start at HIGH mode. Press it again to
turn off the unit. The fan inside will power off 30s later in HIGH / LOW mode.
MODE
In working mode, press the button “ ” to choose the working modes which cycles
as HIGH - FAN - LOW - HIGH, the corresponding indicator lights up, red - blue -
green - red, in turn.
LED displayer
Mode
Temperature
ON / OFF button
PH-1903-15
220-240 V~
50 / 60 Hz
1500 W
II
TECHNICAL DATA
Model
Voltage
Frequency
Power
Protection Class
GB
48
|
49
case of accidental tipping off (90° forward). When the heater stop working, the fan
inside will power off 30s later, the LED display and indicator light will flash to alert
the user to correct the appliance, meanwhile, the buzzer will beep continuously.
The heating is resumed after the appliance is right up, the LED display and
indicator light stop flashing and the buzzer stops alarming.
Note:
the appliance works normally except that it is tilted 90° forward.