Ayce 7613164540928, Operator'S Manual

Page: 44 / 49

GB
GB
| 86 87
180615_ayce_NC900BS_IM 180615_ayce_NC900BS_IM
• Lift the sander off the work before switching off. Remember to keep your hands
away from the moving belt, as it will continue to move for a short time after the
machine is switched off.
• If there are still scratches on your work after sanding, try either of the following:
• Go back to a coarser grit and sand the marks out before recommencing with the
original choice or,
• Try using new sanding belt of the same grit to eliminate the unwanted marks
before progressing to a finer grit and finishing the job.
MAINTENANCE
CAUTION!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.