Pedicure Spa Operation
WARNING: It is important to properly clean and disinfect the basin before initial use and after each use.
Adding Water to Pedicure Spa
1. Close drain by turning overflow (drain) knob counter-clockwise until it stops.
2. Lift up on the three way faucet to add water to the basin. Follow color indicators, red (hot) and blue (cold),
located on the handle or turn the handle counter-clockwise for cold and clockwise for hot.
3. Fill basin until the jet is submerged by at least 1” of water. Refer to diagram below for a visual example.
CAUTION: Water temperature should never exceed 101° F (38° C). Always check water temperature before use.
4. Push the handle on faucet down to shut off water.
Using the Whirlpool Jet
WARNING: Do not run dry! Basin must be filled with water to at least minimum level.
1. Check to make sure jet cover is secured in place. The discharge ports must be positioned at 3 and 9 o’clock. On
magnetic jets the cover will lock into the 4 dimples on the magnetic field. Impacts on the jet cover can cause
damage and shorten its life expectancy.
2. Press the air button to turn on both the jet and LED light located in basin.
3. Press the air button again to turn off the jet and LED.
Removing Water from Pedicure Spa
1. Before draining water make sure whirlpool jets are off and have stopped completely.
2.
A. For floor drains, turn the overflow knob clockwise until is stops, water level will begin to lower.
B. For wall drains, turn the overflow knob clockwise until is stops. It is important to close the cap for each use, as
failing to do so will result in contamination of the system.
C. For power drains (discharge pump only), turn the overflow knob clockwise until is stops. Then press the air
button to engage the pump to remove water. It is recommended to turn off pump if all water has been drained.
Pump can overheat if operated for more than 10 minutes.
