3
REV. 9/25/2019 INSTMITO-03
Audio Level Adjustment
1.
Locate the potentiometer on the interface by the 16-pin harness.
2.
Turn the volume of the radio up 3/4 of the way.
3.
With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower.
4.
Once at a desired level, audio level adjustment is complete.
INSTALLATION
PROGRAMMING
Attention!
The factory satellite radio and Bluetooth modules must be disconnected from the
vehicle. Failure to perform these steps will cause the factory amplifier to not play properly.
1.
Find and disconnect the factory satellite radio module.
• The satellite module for the Lancer and Outlander can be located high in the passenger
side kick panel.
2.
Find and disconnect the factory Bluetooth module.
• The Bluetooth module for the Lancer can be located behind the glove box, up high.
• The Bluetooth module for the Outlander can be located below the factory radio.
3.
Connect the
MITO-03 harness
to the
MITO-03 interface
, and then to the wiring harness in
the vehicle.
4.
If an
ASWC-1
(sold separately) will be used, do not connect it until the
MITO-03
is
programmed and fully functional.
Attention!
If the interface loses power for any reason, the following steps will need to be
performed again.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note:
If the radio doesn’t come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, then try again.
• Turn the key to the off position, then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
ADJUSTMENTS