7
PROGRAMMING THE SWC
After all connections are made, turn ignition on and wait fifteen seconds. After that
time period test SWC functions.
REMAPPING THE SWC BUTTONS
Let’s say you have the FRST programmed to your vehicle and your radio and you
want to change the button assignment for the steering wheel controls. For instance
you would like Seek Up to be Mute.
This process is the same as manually programming the FRST (please refer to the
Manual Programming section) with a couple of notes:
• The FRST must have detected the vehicle and radio it is attached to before you
can remap any buttons.
• You can only start the remapping of the steering wheel controls process within
the first 20 seconds of turning the ignition key on. If you wait longer then the 20
seconds you will have to turn the ignition off then back on again.
• Within the first 20 seconds if any button other then Volume Up or Volume Down
is pushed, the remapping process will stop.
• If during the remapping process no button is pushed for 30 seconds the
remapping process is aborted and the original settings are reset.
SO LET’S BEGIN THE REMAPPING PROCESS:
1. Ideally having the FRST visible is recommended since you can see the led
flashes to confirm button recognition.
2. Turning off the radio is recommended
3. Within the first 20 seconds of turning the ignition on, press and hold down the
Volume Up button for at least 25 seconds.
