2
CONNECTIONS
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
Note:
If installing an AXSWC (sold separately), there will be an accessory wire on the AXTO-
NI1 harness to connect as well.
• Connect the
Blue/White
wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Tape off and disregard the following (13) wires, they will not be used in this application:
Blue/Pink
,
Blue/White
,
Brown
,
Gray
,
Gray/Black
,
Green
,
Green/Black
,
Green/Purple
,
Purple
,
Purple/Black
,
Light Green
,
White
,
White/Black
From the AXTO-NI1 harness to the aftermarket radio:
• Connect the
Black
wire with a ring terminal to chassis ground.
• Connect the
Yellow
wire to the battery wire.
• If installing an AXSWC (sold separately), connect the
Red
wire to the accessory wire.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
Note:
Before connecting this wire, also refer to the “AXCSD-6V 12-volt to 6-volt” converter section
.
• Connect the
Light Green
wire to the parking brake wire.
• If retaining the factory AUX-IN jack, connect the
Red
&
White
RCA jacks to the AUX input.
• If retaining the factory backup camera, connect the
Yellow
RCA jack to the reverse camera
input. Please reference “Reverse camera operation” on page 4 if retaining the camera.
12-pin AXSWC harness & 3.5mm jack:
• This 12-pin AXSWC harness & 3.5mm jack are to be used with an
AXSWC
(sold separately)
to retain steering wheel audio controls. If the
AXSWC
is not being used, disregard this
harness and 3.5mm jack. If it is to be used, please refer to the
AXSWC
instructions for radio
connections and programming. Disregard the harness that comes with the
AXSWC
.
AXCSD-6V 12-volt to 6-volt converter:
• Connect the
Black
wire to chassis ground.
• Connect the
Blue/Red
wire to the
Red
wire labeled “Camera Power 6V”.
• Connect the
Blue/White
wire to the
Green/Purple
wire.
Note:
The
Green/Purple
wire will connect to both the AXCSD-6V, and the aftermarket radio.
