ADVANCED PROGRAMMING
AXTC SERIES
REV. 6/19/19
© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
Integrate •
AxxessInterfaces.com
The AXTC interface can be used in vehicles without steering wheel controls to provide retained accessory power, and also to provide wires
for multimedia radios (park brake / reverse / speed-sense). Follow the steps below to program the AXTC-CH5 for just these features.
Final LED Feedback
1.
From the 3.5mm adapter, tie the
Brown
and
Brown/White
wires together and tape up or use a connector.
2.
Connect the
3.5mm adapter
to the 3.5mm jack from the
AXTC-CH5 harness
.
3.
Program the AXTC-CH5 per the AXTC-CH5 instructions, page 3. Disregard steps 4 and 5.
• At the end of programming the LED light will turn solid
Green
which indicates programming was successful.
• If the LED light turned solid
Red
instead, this means programming has failed. Reset the interface and try again.
• If still no success after resetting and reprogramming the interface, refer to the
Vehicle Troubleshooting
document for
the interface. Ignore the steps referencing steering wheel controls.
Solid Green
Solid Red
Pass
Fail
LED Light
Vehicle Programming Section
