3
REV. 2/4/2020 INSTAXGMLN-09
CONNECTIONS
(CONT.)
INSTALLATION
With the key in the off position:
1.
Connect the
16-pin harness with stripped leads
, and the
AXGMLN-09 harness
, into the
AXGMLN-09
interface
.
2.
If an
AXSWC
(sold separately) will be used, do not connect it until the
AXGMLN-09
is
programmed and fully functional.
Attention!
Do not connect the
AXGMLN-09
harness
to the wiring harness in the vehicle just yet.
For the steps below, the L.E.D. located inside the
AXGMLN-09 interface
can only be seen while
active. The interface does not need to be opened to see the L.E.D.
1.
Start the vehicle.
2.
Connect the
AXGMLN-09 harness
to the wiring harness in the vehicle. The L.E.D. will initially
be
Green
to indicate the interface is powered.
Note:
For the Equinox and Malibu, use part number
AXEXH-GM09
(sold separately) to
extend the wiring harness to the right of the glovebox where the radio brain is located at.
3.
After a few seconds the L.E.D. will turn on solid
Red
while the interface automatically programs
to the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
4.
After the interface is programmed, the L.E.D. will turn on solid
Green
, and the radio will
come back on, indicating programming was successful.
5.
Test all functions of the installation for proper operation, before reassembling the dash.
Note:
The vehicle must be running for the factory camera to power on.
6.
If the interface fails to function, refer to the
Troubleshooting
section.
12-pin AXSWC harness & 3.5mm jack:
The 12-pin AXSWC harness & 3.5mm jack are to be used with an AXSWC (sold separately) to
retain steering wheel audio controls. If the AXSWC is not being used, disregard this harness
and 3.5mm jack. If it is to be used, please refer to the AXSWC instructions for radio connections
and programming. Disregard the harness that comes with the AXSWC.
• Connect the 4-foot long
Green/Black
wire to the
Green/Black
steering wheel control wire
located in the steering column, at the top left. (Figure A)
(Figure A)
Green/Black wire
PROGRAMMING
