AXGMLN-03
3
Connections to be made
12-pin pre-wired AXSWC harness:
• This harness is to be used along with the optional AXSWC (not included) to
retain steering wheel audio controls. If the AXSWC is not being used, disregard
this harness. If it will be used, please refer to the AXSWC instructions for radio
connections and programming.
Note:
Disregard the harness that comes with the AXSWC.
• Connect the
Red
wire to the accessory wire.
• The following wire must be cut before programming the AXSWC:
• For the following vehicles cut the
Green/Orange
wire. If your vehicle is not
listed, do not cut anything:
CHEVROLET
Cobalt 2007-2010
HHR 2006-2011
Malibu 2008-2012
PONTIAC
G5 2007-2009
G6 2010
G6 (5th digit of VIN must
be a J, K, or L)
2009
SATURN
Aura 2007-2009
Sky 2006-2009
Installing the AXGMLN-03
Initializing the AXGMLN-03
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AXGMLN-03 harness,
into the interface.
• Connect the AXGMLN-03 harness to the wiring harness in the vehicle.
• If using the AXSWC, connect it after you initialize and test the AXGMLN-03, with
the key in the off position.
Attention!
If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an AXSWC connect it after you initialize and
test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note:
If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
