AXDI-MB1
2
Connections to be made
(a) From the LD-AX-XSVI-MB1 or LD-AX-XSVI-MB2 harness to the
aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Red
wire to the ignition wire.
• Connect the
Orange
wire to the illumination wire. If the aftermarket radio has
no illumination wire, tape off the
Orange
wire.
• Connect the
Blue
wire to the antenna turn on wire.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
The following wires are for the aftermarket radios that have navigation built in:
• Connect the
Light Green
wire to the parking brake wire of the aftermarket
navigation radio (if applicable).
• Connect the
Blue/Pink
wire to the VSS or speed sense wire of the
aftermarket navigation radio (if applicable).
• Connect the
Green/Purple
wire to the reverse wire of the aftermarket
navigation radio (if applicable).
(b) AXSWC pre-wired harness:
• This harness is to be used in conjunction with the optional AXSWC (not
included) to retain steering wheel controls. If the AXSWC is not being
used, disregard this harness. If it will be used, please refer to the AXSWC
instructions for radio connections and programming.
Note:
Disregard the harness that comes with the AXSWC.
