3
REV. 7/25/2018 INSTAX-CH013-SWC
CONNECTIONS TO BE MADE
Attention!
This interface will work with models that are either non-amplified, or amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models
without
an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the
Red
wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the
Orange/White
wire to it.
Attention!
The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the
Gray
wire to the right rear positive speaker output.
• Connect the
Gray/Black
wire to the right rear negative speaker output.
• Connect the
White
wire to the left rear positive speaker output.
• Connect the
White/Black
wire to the left rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/White
,
Brown
,
Green
,
Green/Black
,
Purple
and
Purple/Black
.
From the LD-BX-CH3 OR LD-BX-CH4 harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Depending on which harness is used, connect either the
Blue
or
Blue/White
wire, to the
power antenna wire.
• Ensure the (2) 4-pin Molex connectors are connected together.
• Connect the 4-pin harness with stripped leads, to the 4-pin Molex connector on the gray
22-pin connector which is loose.
Attention!
The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the
Green
wire to the right front positive speaker output.
• Connect the
Green/Black
wire to the right front negative speaker output.
• Connect the
Purple
wire to the left front positive speaker output.
• Connect the
Purple/Black
wire to the left front negative speaker output.
Continue to 3.5mm jack steering wheel control retention
