8
INSTALLING & PROGRAMMING THE
AX-ADGM03
Attention!
The AX-ADGM03 will work with both the AX-ADBOX1 and AX-ADBOX2 interfaces,
but programming will be different. Refer to the proper page for whichever interface is being
used. Also note, the programming instructions for the AX-ADBOX2 reflect gen. 2. If installing a
gen. 1 AX-ADBOX2, refer to the AX-ADBOX1 programming instructions. Gen. 2 interfaces can be
distinguished by a blue reset button between the (2) connectors.
AX-ADBOX1
Installing the AX-ADGM03
With the key in the off position:
•
Connect the 16-pin harness with stripped leads, and the AX-ADGM03 harness, into the interface
.
• Connect the AX-ADGM03 harness to the wiring harness in the vehicle.
• If an ASWC-1 (sold separately) will be used, do not connect it until the AX-ADGM03 is
programmed and fully functional.
Programming the AX-ADGM03
Attention!
If the interface ever loses power, the following steps will need to be performed
again. Please ensure that the owner of the vehicle knows this.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note:
If the radio doesn’t not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key (or push-to-start button) to the off position, then to the accessory position.
Test all functions of the installation for proper operation, before reassembling the dash.
Note:
To use fade in digital amplified models, ensure the radio is turned up 3/4 of the way.
Continue to Adjusting the AX-ADGM03
DIN jack:
The DIN jack is to be used with the optional AX-LCD (sold separately) to retain satellite radio information.
The AX-LCD can also be used to view which factory sources are active; AUX-IN, rear seat entertainment,
satellite radio
.
CONNECTIONS TO BE MADE
(CONT.)
