2
CONNECTIONS TO BE MADE
Into the vehicle
With the key in the off position:
1.
Connect the
Black
wire of the ASWC-TOY-LEX to ground.
2.
Connect the (2)
Red
wires of the ASWC-TOY-LEX to accessory power.
3.
For all vehicles
EXCEPT
the Lexus SC430, connect
ONLY
the 12-pin connector to the
mating connector in the vehicle. The 6-pin connector on the ASWC-TOY-LEX harness
WILL NOT
be used in the application.
4.
For the 2002-2005 Lexus SC430, connect
ONLY
the 6-pin connector to the mating
connector in the vehicle. The 12-pin connector on the ASWC-TOY-LEX harness
WILL
NOT
be used in the application.
Note:
Disregard the 12-pin connector in the vehicle.
5.
For the 2006-2009 Lexus SC430, connect
BOTH
the 6-pin and 12-pin connectors to
the mating connectors in the vehicle.
To the radio
1.
For the radios below, connect the included female 3.5mm connector with the
Brown
and
Brown/White
wires into the male 3.5mm connector of the ASWC-TOY-LEX
harness.
•
For Eclipse radios:
Connect the Eclipse steering wheel control wires (normally
Brown
and
Brown/Black
) to the
Brown
and
Brown/White
wires of the ASWC-
TOY-LEX.
Brown
of the ASWC-TOY-LEX goes to the
Brown/Black
of the Eclipse and
Brown/White
of the ASWC-TOY-LEX goes to the
Brown
of the Eclipse.
•
For Metra OE:
Connect the SWC Key 1 wire
(Gray)
to the
Brown
wire of the
ASWC-TOY-LEX. Isolate and tape the
Brown/White
wire, it will not be used.
•
For Kenwood or select JVC’s
with a
Blue/Yellow
steering wheel control wire
:
Connect the Kenwood/JVC steering wheel control wire to the
Brown
wire of the
ASWC-TOY-LEX. Isolate and tape the
Brown/White
wire, it will not be used.
Note:
Some of the newer Kenwood radios will auto detect as a JVC. If this is
the case, use a 12k ohm resistor in line between the
Blue/Yellow
and
Brown
wire of the female 3.5mm jack during programming only (remove resistor once
programmed).
2.
For Parrot Asteroid Smart or Tablet:
Connect the ASWC-TOY-LEX male 3.5mm jack
into the AX-SWC-PARROT (sold separately) female 3.5mm jack and plug the 4-pin
end into the corresponding SWC plug on the radio.
Note:
AX-SWC-PARROT required (sold separately) and radio
MUST BE
updated to
rev 2.1.4 or higher.
3.
For XITE radios:
Connect the steering wheel control SWC-2 wire from the radio to
the
Brown
wire of the ASWC-TOY-LEX.
4.
For all other radios:
Connect the 3.5mm jack of the ASWC-TOY-LEX into the jack on
the aftermarket radio designated for an external steering wheel control interface.
Please refer to the aftermarket radios manual if in doubt as to where the 3.5mm
jack goes into.
