9
Installing the Monitor
Power On/Off
Source
Volume
3.5mm A/V Input
Menu
Screen Angle
Standby
Setting the Clock
To install the 10.1" touch screen monitor align the pins on the back of the
monitor with the pins on the front of the unit, and press until it clicks in
place. To remove, press the release tab (next to the SD card slot) and pull
the monitor away from the unit.
Momentarily press the
POWER/SOURCE
button to turn the unit on. Hold
for 2 seconds to turn the unit off.
Press
SRC
to step through all available input modes: Tuner, Disc (which
includes DVD and CD playback), USB, DualMirror, SD, AV1, AV2 and
Camera. Modes of operation are indicated on the OSD On Screen Display.
Optional device, USB flash drive and SD card must be connected/inserted
to appear in the mode selection string. Modes of operation can also be
accessed from the Main Menu screen (see below).
Press the
VOL+
and
VOL-
buttons to increase or decrease playback
volume.
Connect external audio/video devices to this 3.5mm auxiliary A/V input.
Press the key area in the top left corner of the touchscreen to access the
main menu screen. From the main menu, view/select any operational mode
(Tuner, Disc, USB, DualMirror, Bluetooth, SD, AV Front, AV Rear or Camera),
enter the Setup menu, control the screen angle or put the unit in Standby
mode.
Press TILT
p
or TILT
q
to adjust the screen angle up or down.
Press the standby icon (to the right of the TILT icon) to put the unit in
standby mode. Press any spot on the touch screen to exit standby mode.
To set the clock to the current time, press the time display on the Main Menu, then
press the clock icon. Adjust to the desired time, then press the check mark to save
your entry.
General Operation
AVM10BH
OPERATION
