Axopar 37 XC, Owner'S Manual

Page: 27 / 68

4. Product description
WARNING • Never switch off the current when the engine is running, because this
may cause damage to the alternator.
• Never carry out electrical installations when the power is switched on.
• Never modify the boat’s electrical system or diagrams; service and
maintenance must be carried out by a qualified electrician.
• Never modify the nominal rated amperage of the overvoltage protector.
• Never install or replace electrical equipment with components that cause
the circuit’s nominal rated amperage to be exceeded.
• Never leave the boat unattended with the electrical system energized,
except automatic bilge pump, fire protection, and alarm circuits.
4.2.3. Main switches
The different electronic circuits of the boat are controlled by the main switches on the distribution board.
The main switches allow the batteries to be disconnected from all devices that consume electricity. When
the main switches are in the On position, the current is conducted to the distribution board and from there
to different parts of the boat.
The background color of the main switch and the text On shows that the electronic circuit is switched on,
and when the circuit is switched off, the background color is red and the text says Off.
When you leave your boat for any length of time, switch the current off from all main switches and
devices but leave the direct supply switches on.
The base drawing of the boat’s electrical system is presented in
Appendix II .
Main switches of the boat are located in the steering console. Power supply to the engines and devices
is enabled by pulling the Start or Service switch to the lower position and pressing On button. In the
panel, there is main switch for each engine for devices. The boat’s main switch panel is located on the
lower part of steering console.
Under aft deck behind hatches are manually operated main switches. These switches are only for
emergency use. In normal situations, use switches in the steering console.
Current feed to the engine is achieved by turning the Start switch to the On position, feed to other
equipment is achieved by turning the Service switch to the On position and feed to the bow thruster and
windlasses is achieved by turning the Aux switch to the On position.
Axopar 37 XC Document ID: 37XC202004EN
Owner's Manual
© 2020 Axopar Boats Page 25
-
-