10
5
Settings Menu
Introduction
The settings menu displays the current state of each setting within
the PBS03 and enables the item to be changed or adjusted.
Settings can be changed using the front panel of the Synapse
frame (SFR18 or SFR04) or Synapse Setup software.
Please refer to chapter 3 for information on the Synapse front
panel control and Synapse Setup software.
Note: When the PBS03 is in auto mode and switched to channel 2
(if switch back = off) then it’s possible to switch to channel 1 with
GPI contact number 3. See appendix for pin out.
Mode
Mode
determines how the card will switch between the two
channels.
AUTO
the card will switch from the main channel to the backup
channel according to the criteria set (
Carrier
,
TRS
,
Audio
silence
,
Freeze
,
Event
)
MANUAL
: it is possible to switch between the main and backup
channel manually (the actual switch determined by the setting
Manual-Sw
).
GPI-Sw
: the PBS03 has local GPI inputs. With this contact it is
possible to switch between the main and backup channel.
The default setting is
AUTO.
Note:
When the PBS03 is in auto mode and switched to channel 2
(if Switch-back is set to ‘off’) then it’s possible to switch to
channel 1 with GPI contact number 3. See appendix for pin out.
Manual-Sw
If the option
Manual
is selected in
Mode
, this setting allows you
to switch between the Main and the backup channel.
Options are
SDI –In_1
and
SDI-In_2
The default setting is
SDI-In_1
Sw_GPI_1
SW_GPI_1
determines that in case of a GPI closure (GPI
contact one), the MAIN channel is active (for a switch to channel
two close GPI_2 and set the SW_GPI_2 setting to ON).
In
Mode
GPI
should be selected.
The default setting is
OFF
Sw_Carrier_1
Sw_Carrier_1
determines that if an SDI carrier is no longer
