Axnes AS
Document number
Revision
Date
Page 2-15
Audio Feedback
: The volume of the audio feedback can be set. Setting the volume to zero
will disable audio feedback. The setting is persistent over a power off-on cycle.
Headset:
By default, the BST30/35 will detect the connected microphone type. It is possible
to override this and set the microphone type to be unamplified or amplified electret, custom
or low impedance dynamic mic. The setting is persistent over a power off-on cycle.
Mic Equalizer
: For best possible sound quality for those receiving your transmission, it is
possible to adjust the treble of your transmission. It is possible to choose either flat, soft or
sharp. When choosing the best treble setting, a headset connected directly to the intercom
should be used for evaluation of your transmission. The preferred choice can differ when
changing microphone or windsock. The setting is persistent over a power off-on cycle.
Speaker Equalizer
: For best possible sound quality when receiving transmissions, it is
possible to adjust the treble of the received transmission. It is possible to choose either flat,
soft or sharp. When choosing the best treble setting, a transmission from either another
BST30/35 or a headset connected directly to the intercom can be used. The setting is
persistent over a power off-on cycle.
Microphone echo canceller:
Some headsets are prone to vibrations from ear shell
(loudspeaker) transferring down the microphone boom to the microphone causing
echo/distortion/feedback. Microphone echo canceller will remove this unwanted earphone to
microphone coupling. The phenomena are normally only present at very high-volume
settings. The setting set activation point of the echo canceller relative to headset volume
setting, e.g. setting 20 will activate echo canceller at volume setting 20 and higher. Setting 0
is echo canceller disabled, and default setting. The setting is persistent over a power off-on
cycle.
Display Rotate:
This menu is only present if the functionality is enabled in the active
configuration. Select which orientation to read the display. Normal setting is to read display
from the front of the device. The other direction is typically used for reading the display while
the device is in the breast-pocket. The setting is persistent over a power off-on cycle.
Software Version:
Select what to show with the configuration up and down buttons. The
following information can be displayed:
•
Main SW version
•
Crypto Key Name
•
Battery Gauge parameter version
•
CRC of the configuration (can be used to identify the configuration)
•
Capabilities programmed
•
Programmed serial number (Shall match S/N on the Label)
•
Boot SW version
•
SW hash of main SW.
Parameter Reset:
Reset the parameters that can be modified from the Menu back to factory
default values. (Squelch, Audio Feedback, Headset type, VOX max. level, VOX min. level,
Display intensity). To reset the parameters:
•
Enter the Parameter Reset menu
•
Change from Return to Confirm with the configuration up or down arrow
•
Push OK