2)
Insert the Jigger Slug of a
Profile Tool between the
Clamping Bar and Jigger Arm
to hold your profile tool in
place
(image B)
.
3)
Tighten the Hex-Head Bolts
to secure your profile tool
(image C)
.
490 Kane Ct., Oviedo FL 32765 | P.O. Box 621484, Oviedo FL 32762
800-843-7057 or 407-365-2600 | www.axner.com
Axner is a trade name of Laguna Clay Company.
Page 2 of 2
Watch Jolly Jiggering in action on the web!
www.axner.com/powerarm
There are four adjustments when using the power jigger arm:
4)
Use the upright adjusting arm to adjust the height of your jigger
arm
(image D)
.
5)
Use the Leveling Screw to adjust the angle the arm rests at
(image E)
.
6)
Loosen the wing nuts and this will allow you to slide the jigger
slug in the profile tool
(image F)
.
7)
Slide the Jigger Slug within the Clamping Bar
(image G)
.
B
C
D
E
F
G
1)
Place the Clamping Bar on the Jigger
Arm, lining it up with the holes near
the handled end. Insert a Washer and
Hex-Head Bolt into each hole
(image A)
.
Jigger Arm
w/ Handle
Clamping Bar
Axner Power Arm: Installing a Profile Tool
A