Changing the Abrasive Disc and Belt
18
DISCONNECT THE SANDER FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
Fig 42
Step 1 Remove the two table clamping handles (see fig 42).
Fig 44
Step 3 Lift the table assembly away and
place to one side (see fig 44).
Fig 43
Step 2 Remove both Phillips screws on either side of the
table and place safely aside (see fig 43).
Sanding Disc
Fig 45
Step 4 Locate the supplied spanner (C) and using
the 10mm end remove the two nuts on either side
of the extraction housing (see fig 45).
Fig 46
Step 5 Lower the extraction housing (see fig 46).
Fig 47
Step 6 Lift the edge of the disc and, gripping firmly, peel the
disc away from the plate; turning the plate as required to free
the entire disc (see fig 47). Clean the surface of the disc with
a de-greasing cleaner. Allow to dry off and wipe over with a
