12
W H I T E
A X M I N S T E R
W
Initial Assembly...
Fitting the guide fence assembly
Assemble the back rail to the rear of the table by inserting the three Phillips screws through the
predrilled holes in the extrusion. Because of the off-centre hole the back rail cannot be fitted the
‘wrong’ way. (See fig 1 )
Using the four butterfly bolts and washers supplied screw them loosely into the casting. (See fig 2)
Then mount the fence rail by sliding the tongue under the edge of the table, with the cut-outs between
the bolts. Make sure the fence rail is against the edge of the table then tighten the 4 butterfly bolts
securely. (See fig 3)
(DO NOT Over tighten, remember this is a casting, over-tightening could cause the threads to
strip).
Fig 1
Fig 2
Fig 3
Back rail
Table
Butterfly bolt
Fence rail
Phillips screw
driver
Summary of Contents for AWESBS
