Axminster AW150SM, Original Instructions Manual

Page: 19 / 32

SET UP AND ADJUSTMENT
19
8
6
7
4
5
1
10
9
Another method is to adjust the guide rollers beneath the
sliding table. First remove the access panel and place carefully
to one side, see fig 6-7.
Inside and above are two threaded nuts, see fig 8. Adjust the
nuts to raise or lower guide rollers, see fig 9.
Once completed replace the access panel.
0.5mm
Guide roller
Feeler gauge
CHECK THE TABLE IS STILLSQUARE
TO THE FENCE AND MAKE
ADJUSTMENTS IF REQUIRED!
Changing the Spindle Speed
Sliding Table Clearance
DISCONNECT THE MACHINE FROM
THE MAINS SUPPLY!
Open the motor access door to the side of the machine, see fig
1-2. Lower the spindle to its lowest point, if not done so already.
Adjust the two domed head nuts to two each side of the table,
see fig 5. Slot the feeler gauge down the gap between
the two tables from one side and adjust until the gap is set
between (0.5 to 2mm), repeat the procedure for the opposite
side, see fig 10.
Continues over...