Axminster AHDP13B, User Manual

Page: 11 / 40

Assembly
11
Note: On the two radial drills fit the extension arm (2d) into
the mounting arm (2b and 2c) then the tables, see figs 14-
15-16.
Fig 15-16
1. CHECK the drill head, ensure that the two hex socket grub
screws that lock the head in place on the column are
withdrawn and will not foul on the column (1) when the head
is fitted, see fig 17. Put the lower assembly you have just been
working on in the designated position, make sure it is stable
and lift the drillhead (4) over the column (1) and let it drop into
place, see fig 18. Set the drill head approximately fore and aft
and lock in position using the two cap head grub screws
mentioned earlier, see fig 19. Check that the drillhead is
immobile. Everything on the drilling machine is now secured.
Mounting the Drill Head
Fig 17-18-19
2. Lay the drill head on its side, locate the column
spacer block and insert it into machined recess inside the base
of the drill head, see fig 20. Lift the drill head onto the column
as described above and secure using a lift and shift handle (10),
see figs 21.
Fig 20
Radial Pillar Drill Head Only
10
2d
10
Grub screw
4
Spacer block
Continues Over....