Axminster 107703, Original Instructions Manual

Page: 25 / 42

OPERATING INSTRUCTIONS
25
• Never put your hands under or behind the cutter guard.
• Always keep your hands well clear of the rotating cutter.
• Always feed the work piece against the cutter rotation as
shown by the arrow in illustration.
• Use a push stick when working the ends of narrow stock.
• Use a feeding aid if you are going to machine a work piece
shorter than 300mm.
• Always machine the work piece over its entire length.
Recess machining may only be carried out with the
aid of suitable longitudinal work piece stops.
• When working complex shapes, make jigs and guides to
guide the work piece properly and safely.
• Make trial cuts on a piece of scrap before working the actual
work piece.
• Support long work pieces with roller stands or table
extensions.
• Always work one work piece at a time.
Preset stop bolt set at 90˚ degrees
Preset stop bolt set at +05˚ degrees
Spindle at 90˚ degrees
Lock
Un-Lock
Setting the Spindle Angles
1
2
1
2
1
Setting Spindle at 90˚ (degrees)
Setting Spindle at -5˚ (degrees)
2
Continues Over...