Axminster 107685, Original Instructions Manual

Page: 9 / 16

SETTING UP THE GRINDER
9
CONNECT THE GRINDER TO THE
MAINS SUPPLY.
DISCONNECT THE GRINDER
FROM THE MAINS SUPPLY.
ALWAYS WEAR EAR DEFENDERS
AND SAFETY GOGGLES.
Carry out final checks e.g. check the gap between the tool
rest and the stone is correct, check the stone is not badly
deformed (rounded edges, grooved face, etc; unless you
have specifically shaped the stone to these profiles), check
the eye shield is correctly positioned. Have a cooling pot to
hand if you need it. Start the machine, wait until it reaches
full speed. Check it runs smoothly, no knocking or scraping
noises for example. If all ok, switch off the grinder and wait
until it comes to a complete stop. Disconnect the machine
from the mains supply.
CHANGING THE GRINDING STONE
Step 1-2
Using a spanner remove the three nuts and washers from
the stone guard cover and place to one side.
Step 3
Remove side cover and place safely to one side.
Step 4
Grasp the stone using a cloth, use a 24mm spanner to
loosen the nut, remember undo the nut in the direction of
the stone’s rotation as indicated by the arrow on the guard
cover.
Continues Over...