AXMINSTER WORKSHOP AW368WL, Original Instructions Manual

Page: 9 / 28

OPTIONAL ACCESSORIES ASSEMBLY
9
1. Lightly screw in the four M10 bolts into pre-drilled holes
in the left leg stand casting (B), see fig 28 NOTE: leave a
gap between the stand face and bolt heads, ready for the
next step. Remove the tailstock & tool rest banjo and place
aside, see fig 29.
Position Two:
Fig 28-29
Fig 30
2. Move the tailstock assembly over both beds and lock in
place using the locking lever. Tighten the bolts beneath
the bed extension (M), both beds should now be level.
If not, repeat the process until achieved. Replace the stop
pin to the end of the lathe extension (M), see fig 24-25-26-
27.
Fig 24-25-26-27
Locking lever
Setup 2
M
2. Lower the extension bed down, until the keyed holes
are firmly seated down over the bolts. Tighten the
cap head bolts to secure the bed in place, see fig 30.
Continues over...