Axminster Trade AT508WL, Manual

Page: 8 / 32

Assembly
8
Stand Assembly
1. Locate the two lathe stands (M) and the four adjustable feet
(L). Screw the threaded feet into the pre-drilled holes to the
base of the stands, see fig 09.
Fig 09
L
M
2. Place the leg stands on their feet, locate the eight M10 bolts,
spring washer/washers, see fig 10. Place a washer/spring washer
over each bolt, using a lifting device or get assistance lift the
lathe bed up about 700mm from the floor. Line up the four
machined holes two each end of the lathe bed with the holes
in the leg stands (M) and secure in place with the four M10
bolts. Using a 17mm socket or spanner securely tighten, see figs
11-12-13.
Fig 10
Fig 11-12-13
3. Before replacing the headstock banjo/tool rest and
tailstock to the lathe bed, remove the oil residue from all
machined surfaces, see fig 14-15.
Fig 14-15
M10 Bolt
700mm