Axminster Trade AT430DS, Original Instructions Manual, Page: 6 / 42

5
recommended. Wear protective hair covering to contain long hair.
13.
ALWAYS USE SAFETY GLASSES.
Also use face or dust mask if cutting operation is
dusty. Everyday eyeglasses only have impact resistant lenses, they are NOT safety
glasses.
14.
SECURE WORK.
Use clamps or a vise to hold work when practical. It’s safer than
using your hand and it frees both hands to operate tool.
15.
DON’T OVERREACH.
Keep proper footing and balance at all times.
16.
MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for best and safest
performance. Follow instructions for lubricating and changing accessories.
17.
DISCONNECT TOOLS
before servicing; when changing accessories, such as blades,
bits, cutters, and the like.
18.
REDUCE THE RISK OF UNINTENTIONAL STARTING.
Make sure switch is in off
position before plugging in.
19.
USE RECONNENDED ACCESSORIES.
Consult the owner’s manual for
recommended accessories. The use of improper accessories may cause risk of injury or
persons.
20.
NEVER STAND ON TOOL
Serious injury could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
21.
CHECK DAMAGED PARTS.
Before further use of the tool, a guard or other part that
is damaged should be carefully checked to determine that it will operate properly and
perform its intended function-check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may affect its operation.
A guard or other part that is damaged should be properly repaired or replaced.
22.
DIRECTION OF FEED.
Feed work into a blade or cutter against the direction of
rotation of the blade or cutter only.
23.
NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Don’t
leave tool until it comes to a complete stop.
24.
MAME SURE TOOL IS DISCONNECTED
from power supply while motor is being
mounted, connected or reconnected.