Axminster Trade 501196, Manual

Page: 11 / 52

Initial Assembly
11
Fig 12
Fig 13
Fig 14
Fig A
Fig B
When everything is tightened up, the machine can
now be tipped over, towards its blind face until it is
resting on the pallet with its legs on the floor. Lift
the machine upright. (See figs 13-14)
Blind face
Side extension table
Locate the rear table (6) and the other 4 No. M8
caphead bolts and washers (9). Mount the table
onto the brackets, Note: that the securing bolts
need to feed through the elongated holes in the
bracket (7), the rear extension table is spaced off
the main table to allow clearance for the rear
clamping rail and the rip fence. Leave all bolts
finger tight at this time. (See figs 15-16)
Fig 15
Fig 16
Elongated holes
7
Continues Over....
Side Extension Table
Locate four M8 x 16mm hexhead bolts and washers.
Ensure the table is correctly orientated. Stand the
back end of the side extension table (3A) on the
floor, close to the front and edge of the main saw
table (1), with the underside of the table facing the
front of the saw. Lift the table up and introduce a
bolt and washer through the first hole in the table
and screw it into the first threaded hole along the
main table edge. Repeate for the remaining bolts.
Place a level across both table surfaces and tighten
the bolts, (See figs A-B).
1
3A
M8 x 16 Bolt