Axis Q3517-SLVE, Installation Manual

Page: 11 / 152

AXIS Q3517-SLVE Network Camera
To route the cables along the wall and through the side hole on the mounting bracket:
1. Attach the adhesive gasket to the back of the mounting bracket.
2. Unscrew the plug from the side hole on the mounting bracket.
3. Route the network cable (and the multicable if required) through the conduit and
through the hole in the mounting bracket.
4. Attach the mounting bracket to the wall with appropriate stainless screws.
5. Attach the conduit to the mounting bracket.
Connect the cables and attach the camera to the mounting bracket
1. Insert the microSD card in the camera unit (optional).
2. Remove the cable gasket for the network cable from the unit casing, see
Product
overview on page 8 .
3. Pull to remove the tab on the gasket, and use the provided connector guard to push the
network cable through the gasket. Pull the network cable back slightly so that the
cable gasket adjusts itself on the cable.
NO NO
NOTICE
TICE
TICE
Not pulling the cable back could cause water to seep in and damage the product.
4. If using a multicable, remove the other cable gasket from the unit casing and discard it.
5. Pull the cables through the unit casing and attach the cable gaskets to the unit casing.
6. Connect the cables to the camera unit.
7. Pull the springs aside in the unit casing and attach the camera unit to the unit casing,
pulling the cables through the cable gaskets to shorten them as required.
11
EN