Axis Q1614-E, Installation Manual, Page: 13 / 126

AXIS Q1614–E Network Camera
Green Steady green for normal operation.
Amber
Steady during startup and when restoring settings.
Status
Red Slow flash for failed upgrade.
Green Normal operation. Power
Amber
Flashes green/amber during firmware upgrade.
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go
to Setup > System Options > Ports & Devices > LED . See the online help for more
information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System
Options > Maintenance .
• The Power LED can be configured to be unlit during normal operation. To configure, go
to Setup > System Options > Ports & Devices > LED . See the online help for more
information.
• The Network LED can be disabled so that it does not flash when there is network traffic.
To configure, go to Setup > System Options > Ports & Devices > LED . See the online
help for more information.
LED Color Indication
Green Normal operation. Housing
(fan and
heater)
Flashing
green Single flash: Heater error
Double flash: Fan error
Triple flash: General error
Alarm events will be triggered through the camera’s input port.
Contact your Axis reseller for information about spare parts and
troubleshooting.
Note
This status LED referred to in the table above is located in the housing.
13
E
N
G
L
IS
H