AXIS P1435–LE Network Camera
Video
If using automatic
Exposure control
, set the IR cut filter to
Auto
to automatically switch between
On
and
Off
according to the
lighting conditions.
The camera lens is IR corrected, which means that it maintains focus in mixed light. A small focus adjustment is recommended
when IR illumination is used. Select
Enable focus adjustment for IR illumination
to automatically adjust the focus when the IR cut
filter switches between on and off.
The
Day/Night shift level
bar helps determine when the camera will shift from day mode to night mode. Normally, the camera
automatically changes mode from day to night when very dark (level 100 in the slider). By setting
Day/Night shift level
to a
lower value, the camera will change to night mode earlier.
Built-in IR Illuminations LEDs
WARNING
Risk of eye injury. Do not look directly into the IR LED at short distance. Since the light provided from the IR LED is outside of
the visible range, it is not possible to see if it is active. Use the camera to check if the IR illumination is active.
The IR illumination can be activated or de-activated, and its intensity can be increased or decreased by moving the slider, from
the product’s
Live View
page.
Other settings can be defined from
Setup
>
Video
>
Camera Settings
.
De-select the
Enable IR illumination
option to disable IR illumination altogether. If you disable the
Synchronize IR illumination with
day/night
option, IR illumination will not be synchronized with day/night changes.
View Area
A view area is a cropped part of the full view. Each view area is treated as a video source in
Live View
and has its own video
stream and PTZ settings.
When setting up a view area it is recommended that the video stream resolution is the same size as or smaller than the view area
size. Setting the video stream resolution larger than the view area size implies digitally scaled up video after sensor capture,
requiring more bandwidth without adding image information.
To enable, go to
Video > Camera Settings
and select
Enable View Areas
.
To add a new view area:
1. Go to
Video > View Area
.
2. Click
Add
.
3. The new view area appears under
Selected view area
. Enter a descriptive name in the
Name
field.
4. Select an
Aspect ratio
and a
Video stream resolution
.
5. A new view area covers the whole image. Use the mouse to move and resize the view area.
6. Select
Enable PTZ
to enable digital PTZ for the view area.
7. Click
Save
to save the settings.
To modify a view area, select the view area in the list and modify the settings as required. Click
Save
.
To remove a view area, select the view area and click
Remove
.
Note
The PTZ functionality is useful during installation of the Axis product. Use a view area to crop out a specific part of the
full view.
22
